Remove the arms by pulling out the cap and remove the bolt with a Torx 45 bit.

Also remove the armrest "Stop Pin"
with the same Torx bit.

Remove the screws holding on the seat track covers.

Remove the 4 bolts holding the cushion pan.

These are 10 mm bolts.

There are 2 in the front going in from the sides,
and 2 in the rear pointing frontward.

Remove the cushion pan.

If the 'Recliner Cable' runs through the pan:
 Click Here to see more
 about the 'Recliner Cable'.
 

The 4 bolts hold the pan to the frame.

Power adjuster seats are the same,
the motors and levers stay in the car,
just remove the pan.

Remove the old upholstery:

Un-do the plastic clips from the bottom,
pull off the old upholstery,
and remove the old hog-rings.
 

Install the new leather:

Position the new leather upholstery,
hog-ring on in the original manner.

(Hog-Ring Pliers and Hog-Rings
are supplied in the kit)

Glue on the "Bolster Booster" foam pads.
(included with the kit)
While not required, These
add support to the seat sides
and give the seat a deeper look.
(NOT used on GT seats kit)

Roll the 4 corners on.

Clip the new leather to the frame
in the original manner.

Notice how the new leather is shaped
to leave the bolt holes exposed.



 

The new leather is on and ready to go.
But wait...
You will want to install the
backrest leather first.

Back in the car:

To remove the old backrest upholstery:

Some models have a clip at the bottom,
just open it.
Others have plastic "trays" on the back,
un-screw the trays and release the clips.

Pull off the old upholstery, it is held on with Velcro.
 

Half way up it is hog-ringed to the foam,
remove these 3 old hog-rings.
-

Twist with side cutter pliers (included).

Pull up the old upholstery
and slip it over the headrest clips.

Pop off the headrest clips.