Do Not glue the vinyl to the face of the panel.
Do Not remove the original fuzzy carpet (makes a good pad).
Glue and staple the vinyl to the backside perimeter.

Remove seats, console,
and “B” pillars.

Remove screws from console groove.

Pull off panel. It has door panel clips.

Lay panel face down on the vinyl.

DO NOT glue the face of the panel !!

Glue and staple around the back.

Cut the vinyl 2 inches in from the console opening.

Flip panel over and spray glue into the
console groove and onto the vinyl.

Press vinyl into the console groove,
wrap edge around to the backside.
Glue and staple.